Wednesday, November 18, 2026

MFJ-9406 6 meter transceiver + Frequency Counter

I don't like to leave a hamfest swapmeet empty-handed.  I kept walking past this MFJ-9406 6m SSB transceiver, but before I left the fellow who was cleaning up his table, caught me looking at it.  I told him I didn't NEED it.  He offered it to me for $20 in working condition.  How could I say "no"?

It was in original condition with a Radio Shack mic, and didn't have the CW module.  My friend had one of these, and with a good 6 meter opening had made some good contacts with it since it puts out 10 watts.  The issue as always (even with the IC-502 that I recently upgraded), is that a purely analog radio has no real confirmation of the actual operating frequency.  In the modern world this isn't a limitation I like to live with.  The VFO operation is nice and has the fine tuning knob, and if I did want to pay the exorbitant shipping fees for the kit, I would have considered upgrading it to a Digi-VFO.

What I did have on hand was a PLJ-096OLED-H1 Frequency Counter module, which could easily be powered from the radio, and sniff the VFO frequency.  This clever little module has a built-in offset for heterodyne radio use.  A quick poke through the menu was all that was needed to add +10Mhz to the display.

Unfortunately, the board was a hair too tall to install inside the case above the fine tuning and volume pots.  So why not take advantage of shielding the inner-workings of the radio from any digital hash from the counter's microprocessor, and save me from cutting a window in the front panel of the radio.  I could get away with drilling a few holes if I mounted it to the front of the radio and just running the coax and power leads into the case of the radio.  I put my son to work designing a dust cover to shield in 3D, to be realized in ABS plastic for the frequency counter module.  The cover snaps on easily and has a gap for the power and coax to exit underneath, which provides convenient access to the menu buttons from underneath with a toothpick or screwdriver.  It doesn't stick out any further than the main tuning dial, so no harm done to the aesthetics of this cute little radio.

The best place to pick up the VFO output was at the Source lead of FET transistor Q7.  There's a small coax jumper JMP1A that goes from the transistor over to the mixer, so that's where I installed a 12 pF capacitor (with short leads) to sniff the signal into the frequency meter without loading down the existing circuit.  It works great!  Just turn the main dial and then the fine tuning dial watching the digital readout.  The club 6 meter beacon W3HZU/B on 50.062 Mhz came in loud and clear.

I put a 200 ohm resistor in line with the power lead and ran it across the top of the case and into the power switch where the backlight lamp for the meter was terminated.  The black power lead went under the screw head and washer than fastened the frequency counter to the front of the case.




No comments:

Post a Comment